GT-CTS15.6

In industrial and ordering scenes the gain is in rapid repeat tapping: scan-start, confirm-order, emergency-stop acknowledgement. 5 ms cuts the "did it register" hesitation that shows up on slower panels during 8-hour shifts. For slow dragging or menu browsing you won't feel a difference vs 10 ms — it's the high-frequency button work that benefits.

Yes, slightly. A 15.6" G+G stack weighs meaningfully more than G+F, so don't rely on just sticky tape at the corners. Use a perimeter support frame or a bonded edge gasket so the weight is carried evenly. If your product is portable or vibration-mounted, tell us — we'll suggest a shock-absorbing gasket spec.

Standard PCAP needs conductive contact, so thin nitrile may not register by default. We can tune the controller sensitivity and enable glove mode before shipment — thin ESD/nitrile gloves usually work after tuning. Thick insulated winter gloves won't; for that you'd need a dedicated gloved-touch firmware profile, which we can flash on request.

Yes. G+G is rigid enough for tabletop/facia mounting. For a counter-top ordering station, we recommend a slight recess (0.5–1 mm below the surround) so the glass edge doesn't catch cups and sleeves, and a rounded-edge cover glass (2.5D) option if your ID allows it. Flat 2D edge is standard; 2.5D needs tooling confirmation.

Two things: laminate the sensor in a temp clean area or use a peelable protective film we supply, and keep the FPC connector covered until the final USB plug-in. Dust between G+G layers isn't repairable in the field, so the seal has to be done right the first time — we can pre-assemble the bonded stack and ship it ready-to-mount.